BRAKE PAD REPLACEMENT <Short wheelbase, Long wheelbase-3000>


<FRONT>
caution When replacing, replace both brake pads (right and left) as a set.
1.Remove the guide pin lock bolt, swivel the caliper assembly upward and retain it with a wire or similar tool.
2.

Remove the following parts from the caliper body.
(1) Shim
(2) Brake pad assembly
(3) Clip

3.
caution Keep grease or other soiling off the pad and brake disc friction surfaces.
Clean the piston part, and press the piston into the cylinder using the special tool piston expander (MB990520).
4.Assemble the shim, brake pad assembly and clip to the caliper support, and tighten the guide pin lock bolt to the specified torque.
Tightening torque: 88 ± 5 N·m
note Install at pad assembly with a wear indicator to the inside of the wheel with the indicator facing downwards.

LUBRICATION POINT

<REAR>
caution When replacing, replace both brake pads (right and left) as a set.
1.Remove the lock pin, swivel the caliper assembly upward and retain it with a wire or similar tool.
2.

Remove the following parts from the caliper body.
(1) Shim
(2) Brake pad assembly
(3) Clip
note
  • The brake pad assembly with wear indicator is installed only to the inner side of the brake disc of the left-side brake at factory.<Vehicles with low steel brake pads>
  • As for the accessory pad set, the brake pad with wear indicator has been established to the inner side of the brake disc on both right side brake and left side brake.

3.
caution Keep grease or other soiling off the pad and brake disc friction surfaces.
Clean the piston part, and press the piston into the cylinder using the special tool piston expander (MB990520).
4.Assemble the shim, brake pad assembly and clip to the caliper support, and tighten the lock pin to the specified torque.
Tightening torque: 44 ± 5 N·m
note Install at pad assembly with a wear indicator to the inside of the wheel with the indicator facing downwards.

LUBRICATION POINT