|
|
If the tie rod end is disengaged from the knuckle, renew the tie rod end dust cover and retainer by following the procedure below.
|
|
|
1.Unclip the clip ring to remove the dust cover.
|
|
2.
| caution |
Be careful not to damage the ball joint stud.
|
Use a flat-tipped screwdriver to remove the retainer.
|
|
3.Apply multi-purpose grease to the new retainer, and assemble it to the new dust cover.
|
|
4.Fill multi-purpose grease inside the dust cover as shown.
Amount to use: 4 ± 1g
5.Apply multi-purpose grease to the dust cover lip.
6.Tape the stud threads to avoid damage.
|
|
7.
| caution |
Ensure grease does not come into contact with the ball joint threads and tapers. Wipe off the grease if contaminated.
|
Install the ball joint to the dust cover.
8.Secure the dust cover with the clip ring.
|