|
|
The service procedures other than below are the same as that for 10 MY OUTLANDER.
|
|
Refill with specified engine oil.
Specified Engine Oil
- ACEA classification: A1/B1, A3/B3, A3/B4 or A5/B5
- ILSAC classification: ILSAC certificated oil
- API classification: SM
Total quantity (Includes volume inside engine oil filter):
4.3 L
| note |
SAE 0W-20, 0W-30, 5W-30, and 5W-40 engine oils can only be used if they meet ACEA A3/B3,
A3/B4 or A5/B5 and API SM specifications.
|
|
|
|
1.Start the engine and allow it to warm up until the temperature of the engine coolant
reaches 80°C to 90°C.
|
|
|
2.
| warning |
Use care as engine oil could be hot.
|
Remove the engine oil filler cap.
|
|
|
3.Remove the engine room under cover extension (Refer to GROUP 51 - Under Cover  ).
|
|
|
4.Remove the engine oil pan drain plug to drain engine oil.
|
|
|
5.Install a new engine oil pan drain plug gasket and then tighten the engine oil pan
drain plug to the specified torque.
Tightening torque: 39 ± 5 N·m
|
|
6.Refill with specified quantity of engine oil.
Specified Engine Oil
- ACEA classification: "For service C1, C2, C3 or C4"
- JASO classification: "For service DL-1"
Total quantity (Includes volume inside engine oil filter): 5.3 L
7.Install the engine oil filler cap.
8.Let the engine run for a few minutes.
9.Stop the engine, and then check the engine oil level using the engine oil level gauge
after a few minutes.
10.Install the engine room under cover extension (Refer to GROUP 51 - Under
Cover ).
|
|
|
1.Start the engine and allow it to warm up until the temperature of the coolant reaches
80 °C to 90 °C.
|
|
|
2.
| warning |
Use care as engine oil could be hot.
|
Remove the engine oil filler cap.
|
|
|
3.Remove the engine oil pan drain plug to drain engine oil.
|
|
|
4.Install a new engine oil pan drain plug gasket, and then tighten the engine oil pan
drain plug to the specified torque.
Tightening torque: 39 ± 5 N·m
|
|
5.Refill with specified quantity of engine oil.
Specified Engine Oil
- ACEA classification: A1/B1, A3/B3, A3/B4 or A5/B5
- ILSAC classification: ILSAC certificated oil
- API classification: SM
Total quantity (Includes volume inside engine oil filter): 4.2 L
| note |
SAE 0W-20, 0W-30, 5W-30, and 5W-40 engine oils can only be used if they meet ACEA A3/B3,
A3/B4 or A5/B5 and API SM specifications.
|
6.Install the engine oil filler cap.
7.Check engine oil level.
|