REMOVAL AND INSTALLATION



caution When the fuel injector is replaced, initialise the learned value using M.U.T.-III (Refer to GROUP 00 - Precautions before Service, Initialisation Procedure for Learning Value in MPI Engine ).
Pre-removal operation
  • Fuel Line Pressure Reduction (Refer to ).
  • Engine Upper Cover Removal (Refer to GROUP 11A - Camshaft ).
  • Air Intake Hose Removal (Refer to GROUP 15 - Air Cleaner ).

Post-installation operation
  • Air Intake Hose Installation (Refer to GROUP 15 - Air Cleaner ).
  • Fuel Leak Check.
  • Engine Upper Cover Installation (Refer to GROUP 11A - Camshaft ).





Removal steps


1.
Control wiring harness connection
<<A>>
>>F<<
2.
Fuel high-pressure hose connection


·
Emission control vacuum pipe assembly (Refer to GROUP 14 - Water Hose and Water Pipe ).


3.
Engine oil level gauge

>>E<<
4.
Injector protector rear

>>E<<
5.
Bracket
<<B>>
>>E<<
6.
Fuel delivery pipe and fuel injector assembly

>>D<<
7.
Fuel injector support

>>C<<
8.
Fuel injector assembly

>>B<<
9.
Fuel injector O-ring

>>A<<
10.
Fuel injector O-ring


11.
Fuel injector


12.
Fuel delivery pipe

REMOVAL SERVICE POINTS


For removal service points, follow the same service procedures as 10 MY OUTLANDER.

INSTALLATION SERVICE POINTS


For service points other than below, follow the same service procedures as 10 MY OUTLANDER.

>>E<< FUEL DELIVERY PIPE AND FUEL INJECTOR ASSEMBLY/BRACKET/INJECTOR PROTECTOR REAR INSTALLATION


1.Apply a small amount of petrol to the O-ring at the end of fuel injector assembly.
2.
caution When installing the fuel delivery pipe and fuel injector assembly to the inlet manifold, pay attention to avoid damage to the O-ring at the end of the fuel injector assembly.
Install the fuel delivery pipe and fuel injector assembly to the inlet manifold.
3.Tighten the mounting bolts of the bracket and the protector loosely.

4.Loosen the four mounting bolts and nuts of the inlet manifold.
5.Loosen the inlet manifold stay mounting bolts (Refer to GROUP 15 - Inlet Manifold ).

6.Tighten the mounting bolts and nuts of the fuel delivery pipe, the bracket, the protector and the inlet manifold in the order shown loosely.
Tightening torque: 3.5 ± 1.5 N·m
7.Tighten the mounting bolts and nuts in the order shown to the specified torque.
Tightening torque: 20 ± 2 N·m
8.Tighten the inlet manifold stay mounting bolts (Refer to GROUP 15 - Inlet Manifold ).