REMOVAL AND INSTALLATION



caution
  • When the throttle body assembly is replaced, initialise the learned value using M.U.T.-III (Refer to GROUP 00 - Precautions before Service, Initialisation Procedure for Learning Value in MPI Engine ).
  • Never loosen the screw fixing the throttle body assembly resin cover. If the screw is loosened, the sensor incorporated in the resin cover is misaligned and the throttle body assembly does not work normally.
Pre-removal operation
  • Engine Upper Cover Removal (Refer to GROUP 11A - Camshaft ).
  • Engine Coolant Draining (Refer to GROUP 14 - On-vehicle Service, Engine Coolant Replacement ).
  • Air Intake Hose Removal (Refer to GROUP 15 - Air Cleaner ).

Post-installation operation
  • Air Intake Hose Installation (Refer to GROUP 15 - Air Cleaner ).
  • Engine Coolant Refilling (Refer to GROUP 14 - On-vehicle Service, Engine Coolant Replacement ).
  • Engine Upper Cover Installation (Refer to GROUP 11A - Camshaft ).





Removal steps

>>B<<
·
Initialisation operation (only at installation)


1.
Control wiring harness connection


2.
Battery wiring harness connection


3.
Throttle body water feed hose connection


4.
Throttle body water return hose connection


5.
Stay


6.
Connector bracket


7.
Throttle body assembly

>>A<<
8.
Gasket

INSTALLATION SERVICE POINTS


For installation service points, follow the same service procedures as 10 MY OUTLANDER.