REMOVAL AND INSTALLATION


caution
  • The parts indicated by *1 should be temporarily tightened, and then fully tightened with the vehicle standing on the ground and the curb weight condition.
  • The parts indicated by *2 are the bolts/nuts with friction coefficient stabilizer. In removal, ensure there is no damage, clean dust and soiling from the bearing and thread surfaces, and tighten them to the specified torque.
Pre-removal operation
  • Rear Height Sensor Removal (RH) (Refer to GROUP 54A - Height Sensor ). <Vehicles with Headlamp Automatic Levelling System>
  • Cargo Floor Box (LH/RH) Removal (Refer to GROUP 52A - Trim ).
  • Rear Speaker Box Assembly Removal (RH) (Refer to GROUP 54A - Speaker ).

 Post-installation operation
  • Rear Speaker Box Assembly Installation (RH) (Refer to GROUP 54A - Speaker ).
  • Cargo Floor Box (LH/RH) Installation (Refer to GROUP 52A - Trim ).
  • Rear Height Sensor Installation (RH) (Refer to GROUP 54A - Height Sensor ). <Vehicles with Headlamp Automatic Levelling System>




Removal steps


1.
 Stabilizer link connection
<<A>>
2.
 Lower arm and trailing arm connection


3.
 Shock absorber and lower arm connection


4.
 Shock absorber mounting nut
<<B>>
 >>A<<
 5.
 Shock absorber assembly

REMOVAL SERVICE POINTS
For removal service points, follow the same service procedures as 10 MY OUTLANDER.

INSTALLATION SERVICE POINT
For installation service points, follow the same service procedures as 10 MY OUTLANDER.