REMOVAL AND INSTALLATION


caution
  • Disconnect the negative auxiliary battery terminal and wait for 60 seconds or more before starting work. Insulate the disconnected (-) terminal by wrapping the tape (Refer to the item 5 of Service Precautions ).
  • Never attempt to disassemble or repair the air bag module. If faulty, replace it with new one.
  • Do not drop the air bag module or allow contact with water, grease or oil. If denting, cracking, or deformation is discovered, replace it with new one.
  • Store the air bag modules on a flat surface with the deployment surface facing up. Also, do not put anything on it.
  • Do not store the air bag module in a place more than 93°C.
  • When the air bags have been deployed, replace the and air bag module with new one.
  • Put on gloves and safety glasses when handling deployed air bags.
  • When discarding the air bag module, make sure to deploy the air bag before the disposal (Refer to ).

Pre-removal operation
  • Electric motor switch the LOCK (OFF) position.
  • Disconnect the negative auxiliary battery terminal.






Removal steps


·
Glove box (Refer to GROUP 52A - Instrument panel assembly )
<<A>>

1.
Passenger’s (front) air bag module connector


·
Secret box (Refer to GROUP 52A - Instrument Panel Assembly .) <RHD>
<<B>>

2.
Passenger’s (front) air bag module



Installation steps

>>A<<
·
Pre-installation inspection


2.
Passenger’s (front) air bag module


·
Secret box (Refer to GROUP 52A - Instrument Panel Assembly .) <RHD>


1.
Passenger’s (front) air bag module connector


·
Glove box (Refer to GROUP 52A - Instrument panel assembly )


·
Connect the negative auxiliary battery terminal.

>>B<<
·
Post-installation inspection

REMOVAL SERVICE POINTS



<<A>> PASSENGER’S (FRONT) AIR BAG MODULE CONNECTOR REMOVAL



Release the claw (1) of the lock lever of the front passenger’s air bag module harness side connector, and lift the lock lever to the direction of the arrow (2), then remove the connector.

<<B>> PASSENGER’S (FRONT) AIR BAG MODULE REMOVAL <RHD>


caution
  • Never use an electric tester to diagnose the air bag module circuit. Never attempt to disassemble the air bag module.
  • The removed passenger’s air bag module should be stored in a clean, dry place with the deployment surface facing up.
  • When discarding the air bag module, discard after deploying the air bag as specified in the service procedure (Refer to ).

Insert a flat-tipped screwdriver or similar tool to the location shown in the figure. After disengaging the tabs, remove the passenger’s (front) air bag module.

INSTALLATION SERVICE POINTS



>>A<< PRE-INSTALLATION INSPECTION


1.Before the installation, check the air bag module (Refer to ).
note Even when installing a new air bag module, perform an inspection before the installation.
2.Connect the negative auxiliary battery terminal.
3.
caution Be sure to turn the ignition key to the LOCK (OFF) position when connecting or disconnecting M.U.T.-III.
Connect M.U.T.-III to the diagnosis connector (16 pin).
4.Electric motor switch to the "ON" position
5.Read the diagnosis code, and check that everything is normal except the air bag module open circuit.
6.Electric motor switch the LOCK (OFF) position.
7.
caution Wait at least 60 seconds after disconnecting the auxiliary battery cable before doing any further work (Refer to ).
Disconnect the negative auxiliary battery terminal cable and wrap it with tapes for insulation.

>>B<< POST-INSTALLATION INSPECTION


1.Electric motor switch to the "ON" position

2.Check that the SRS warning lamp is illuminated for 6 to 8 seconds, and extinguished afterward.
3.If the lamp does not extinguish, perform the troubleshooting (Refer to ).