Code No. U1117 Immobilizer CAN Timeout/ Not equipped


caution If there is any problem in the CAN bus lines, an incorrect diagnosis code may be set. Prior to this diagnosis, diagnose the CAN bus lines .

OPERATION

    ETACS-ECU communicates with EV-ECU via CAN.

DIAGNOSIS CODE SET CONDITIONS

    When the CAN data cannot be received from ETACS-ECU, the diagnosis code No. U1117 will be set.

PROBABLE CAUSES

  • Wiring harness or connector failure of CAN bus line
  • ETACS-ECU malfunction
  • EV-ECU malfunction

DIAGNOSIS PROCEDURE

STEP 1. M.U.T.-III CAN bus diagnostics
Use M.U.T.-III to diagnose the CAN bus lines.

Q. Is the check result normal?
Go to Step 2
Repair the CAN bus line (Refer to GROUP 54C - CAN Bus Diagnostics Table ).

STEP 2. Diagnosis code recheck after resetting CAN bus lines
Recheck if the diagnosis code is set .
(1)Erase the diagnosis code.
(2)Turn the electric motor switch from "LOCK" (OFF) position to "ON" position.
(3)Check if the diagnosis code is set.

Q. Is the diagnosis code set?
Go to Step 3
This diagnosis is complete.

STEP 3. M.U.T.-III other system diagnosis code
Check if diagnosis code is set to the ETACS-ECU.

Q. Is the diagnosis code set?
Troubleshoot the ETACS (Refer to GROUP 54A - Diagnosis Code Chart ).
Go to Step 4

STEP 4. Check whether the diagnosis code is reset
Recheck if the diagnosis code is set .
(1)Erase the diagnosis code.
(2)Turn the electric motor switch from "LOCK" (OFF) position to "ON" position.
(3)Check if the diagnosis code is set.

Q. Is the diagnosis code set?
Replace the EV-ECU (Refer to ).
The trouble can be an intermittent malfunction such as a poor connection or open circuit in the CAN bus lines between the ASC-ECU and the EV-ECU (GROUP 00 - How to use Troubleshooting/inspection Service Points - How to Cope with Intermittent Malfunctions ).