REMOVAL AND INSTALLATION



<Except Euro5b>


Pre-removal Operation
  • Under Skid Plate and Engine Room Under Cover Removal (Refer to GROUP 51 - Under Cover ).

Post-installation Operation
  • Under Skid Plate and Engine Room Under Cover Installation (Refer to GROUP 51 - Under Cover ).





Removal steps


1.
Front exhaust pipe


2.
Exhaust pipe gasket


3.
Seal ring


4.
Centre exhaust pipe


5.
Exhaust pipe gasket


6.
Exhaust main muffler


7.
Dash heat protector panel

<Euro5b>


caution When the DPF is replaced, use the M.U.T.-III to initialise the learning value (Refer to GROUP 00 - Precautions before Service, Initialisation Procedure for Learning Value in DPF System ).
Pre-removal Operation
  • Under Skid Plate and Engine Room Under Cover Removal (Refer to GROUP 51 - Under Cover ).

Post-installation Operation
  • Under Skid Plate and Engine Room Under Cover Installation (Refer to GROUP 51 - Under Cover ).





Removal steps


·
No.2 exhaust gas temperature sensor (Refer to GROUP 17 - Emission Control, DPF System Sensors )


1.
Front exhaust pipe


2.
Exhaust pipe gasket


3.
Seal ring


·
No.2 crossmember (Refer to GROUP 32 - Rear Engine Mounting ) <2WD>


·
No.3 exhaust gas temperature sensor (Refer to GROUP 17 - Emission Control, DPF System Sensors )


4.
Exhaust pressure hose connection


5.
Exhaust pressure pipe and DPF assembly


6.
Exhaust pressure pipe


7.
DPF


8.
Exhaust pipe gasket


9.
Exhaust main muffler


10.
Front floor heat protector panel