Diagnosis Item 13: Diagnose when the M.U.T.-III cannot receive the data sent by engine-ECU.


caution When servicing a CAN bus line, earth yourself by touching a metal object such as an unpainted water pipe. If you fail to do, a component connected to the CAN bus line may be broken.


FUNCTION



TROUBLE JUDGEMENT CONDITIONS



PROBABLE CAUSES



  • Damaged harness wires and connectors
  • Power supply circuit malfunction of the engine-ECU
  • Malfunction of the engine-ECU

DIAGNOSIS PROCEDURE

STEP 1. Connector check: C-01 joint connector (CAN2) and C-103 engine-ECU connector


caution The strand end of the twist wire should be within 10 cm from the connector. For details refer to .

When checking the joint connector, ensure that its wiring harness side and its short pins are not damaged.

Q. Is the check result normal?

Go to Step 2.

Repair the defective connector. Replace the joint connector as necessary.

STEP 2. Resistance measurement at C-01 joint connector (CAN2) and C-103 engine-ECU connector.
caution A digital multimeter should be used. For details refer to .
caution The test wiring harness should be used. For details refer to .


(1)Disconnect the joint connector (CAN2) and the engine-ECU connector, and measure at the wiring harness side.
(2)Turn the ignition switch to the LOCK (OFF) position.
(3)
caution When measuring the resistance, disconnect the negative battery terminal. For details refer to .
Ensure that the negative battery terminal is disconnected.

(4)Continuity between C-01 joint connector (CAN2) terminal No.9 and C-103 engine-ECU connector terminal No.108 <LHD>
OK: Continuity (2 Ω or less)

(5)Continuity between C-01 joint connector (CAN2) terminal No.10 and C-103 engine-ECU connector terminal No.108 <RHD>
OK: Continuity (2 Ω or less)

(6)Continuity between C-01 joint connector (CAN2) terminal No.20 and C-103 engine-ECU connector terminal No.109 <LHD>
OK: Continuity (2 Ω or less)

(7)Continuity between C-01 joint connector (CAN2) terminal No.21 and C-103 engine-ECU connector terminal No.109 <RHD>
OK: Continuity (2 Ω or less)
caution Strictly observe the specified wiring harness repair procedure. For details refer to .

Q. Is the check result normal?

<All the resistances measure 2 Ω or less> Go to Step 3 .

NO : <Either or all of the resistances measure more than 2 Ω> Repair the wiring harness between joint connector (CAN2) and the engine-ECU connector.

STEP 3. Resistance measurement at C-103 engine-ECU connector.
caution A digital multimeter should be used. For details refer to .


(1)Remove the engine-ECU, and measure at the equipment side.

(2)Resistance between C-103 engine-ECU connector terminal Nos.108 and 109
OK: 120 ± 20 Ω
caution Strictly observe the specified wiring harness repair procedure. For details refer to .

Q. Is the check result normal?

<Within 120 ± 20 Ω> Power supply to the engine-ECU may be suspected. Diagnose the fuel system. Refer to .

<Not within 120 ± 20 Ω> Replace the engine-ECU.