|
|
1.Start the engine and allow it to warm up until the temperature of the engine coolant reaches 80 °C to 90 °C.
|
|
|
2.
| warning |
Use care as engine oil could be hot.
|
Remove the engine oil filler cap.
|
|
|
3.Remove the engine room under cover extension. (Refer to GROUP 51 - Under Cover  )
|
|
|
4.Remove the engine oil pan drain plug to drain engine oil.
|
|
5.Use the respective tool in the following table to remove the engine oil filter. <4A9, 4B10>
|
|
Number
|
Special tool
|
MD360935
|
Oil filter wrench (MB991396) or equivalent
|
|
|
|
6.Use the respective tool in the following table to remove the engine oil filter. <4B11-Turbo>
|
|
Number
|
Special tool
|
MD356000
|
Oil filter wrench (MB991610) or equivalent
|
|
7.Clean the filter bracket side mounting surface and ensure the old O-ring has been removed.
|
|
8.Apply a small amount of engine oil to the new engine oil filter O-ring.
9.Where the engine oil filter O-ring touches the engine oil filter bracket flange, tighten the engine oil filter to the specified torque using the commercially-available tool.
|
|
Number
|
Special tool
|
Tightening torque
|
MR984204 <4A9>
|
Commercially- available tool
|
Approximately 3/4 turn (11 ± 1 N·m)
|
MD360935 <4A9, 4B10>
|
Oil filter wrench (MB991396) or equivalent
|
Approximately 1 turn (14 ± 2 N·m)
|
MD356000 <4B11-Turbo>
|
Oil filter wrench (MB991610) or equivalent
|
Approximately 3/4 turn (14 ± 2 N·m)
|
|
10.Install the engine oil pan drain plug and refill the engine oil (Refer to ).
11.Rev the engine a few times, and check to be sure that no engine oil leaks from the installation section of the engine oil filter.
12.Install the engine room under cover extension. (Refer to GROUP 51 - Under Cover )
|