REMOVAL AND INSTALLATION


caution The vehicle speed detection encoder collects any metallic particle easily, because it is magnetised. Make sure that the encoder should not collect any metallic particle. Check that there is not any trouble prior to reassembling it.
Pre-removal and post-installation operation
  • Air cleaner body and air cleaner cover removal and installation <Refer to GROUP 15 - Air cleaner (4A9), (4B1), (BWC)> <Front wheel speed sensor (LH)>
  • Rear scuff plate, rear door opening trim, cargo floor box, trunk room rear end trim, flexible floor plug, flexible floor guide, quarter trim removal and installation (Refer to GROUP 52A - Interior trim ) <Rear wheel speed sensor>





Front wheel speed sensor removal steps


1.
 Bolt (front wheel speed sensor and knuckle connection)


2.
 Front wheel speed sensor connector

>>A<<
 3.
 Front wheel speed sensor grommet

>>B<<
 4.
 Front wheel speed sensor

>>B<<
 5.
 Harness clip



Rear wheel speed sensor removal steps


6.
 Bolt (rear wheel speed sensor and trailing arm assembly connection)


7.
 Rear wheel speed sensor connector

>>A<<
 8.
 Rear wheel speed sensor grommet


9.
 Rear wheel speed sensor


10.
 Protector
note The vehicle speed detection encoder is integrated with the wheel bearing (Front) and the rear wheel hub assembly (Rear), which is non-serviceable.

INSTALLATION SERVICE POINTS

>>A<< FRONT WHEEL SPEED SENSOR GROMMET/REAR WHEEL SPEED SENSOR GROMMET INSTALLATION

Install the front wheel speed sensor grommet and the rear wheel speed sensor grommet to the body panel snugly as shown in the figure.

>>B<< HARNESS CLIP INSTALLATION




Install the front wheel speed sensor to the harness clip as shown in the figure.