REMOVAL AND INSTALLATION




caution The vehicle speed detection encoder collects any metallic particle easily, because it is magnetised. Make sure that the encoder should not collect any metallic particle. Check that there is not any trouble prior to reassembling it.
Pre-removal and post-installation operationRear scuff plate, rear door opening trim, cargo floor box, trunk room rear end trim, flexible floor plug, flexible floor guide, quarter trim removal and installation (Refer to GROUP 52A - Interior trim ) <Rear wheel speed sensor>




Removal steps


1.
Bolt (rear wheel speed sensor and trailing arm assembly connection)


2.
Rear wheel speed sensor connector

>>A<<
3.
Rear wheel speed sensor grommet


4.
Rear wheel speed sensor
note The vehicle speed detection encoder is integrated with the rear wheel hub assembly, which is non-serviceable.

INSTALLATION SERVICE POINT



>>A<< REAR WHEEL SPEED SENSOR GROMMET INSTALLATION



Install the rear wheel speed sensor grommet to the body panel snugly as shown in the figure.