Inspection Procedure 7: ASC Warning Display Stays ON after the Engine is Started.


caution
  • If there is any problem in the CAN bus lines, an incorrect diagnosis code may be set. Prior to this diagnosis, diagnose the CAN bus lines (Refer to GROUP 54C, CAN Bus Diagnostics Table ).
  • Whenever ECU is replaced, ensure that the CAN bus lines are normal.
  • When the hydraulic unit (integrated with ASC-ECU) is replaced, always carry out the calibration of the steering wheel sensor, the G and yaw rate sensor and brake fluid pressure sensor (Refer to , and ).

OPERATION
ASC-ECU sends the illumination request signal of the ASC warning display to the combination meter through ETACS-ECU via the CAN communication.

COMMENTS ON TROUBLE SYMPTOM
This may be caused by faults in the CAN bus line, ETACS-ECU, combination meter or ASC-ECU.

PROBABLE CAUSES

  • Damaged wiring harness and connectors
  • Malfunction of ETACS-ECU
  • Combination meter malfunction
  • ASC-ECU malfunction
  • Control is disabled due to the low voltage
    note Due to the abnormality in the supply voltage, the diagnosis code may not be set even when the ASC warning display illuminates.

DIAGNOSIS PROCEDURE

STEP 1. M.U.T.-III CAN bus diagnosis
Use M.U.T.-III to diagnose the CAN bus lines.

Q. Is the check result normal?
Go to Step 2.
Repair the CAN bus lines. (Refer to GROUP 54C - Troubleshooting .) Then go to Step 7.

STEP 2. M.U.T.-III diagnosis code
Use M.U.T.-III to check the diagnosis code for the ASC system.

Q. Is the diagnosis code set?
Carry out the diagnosis for the diagnosis code. (Refer to .)
Go to Step 3.

STEP 3. Check the ASC-ECU power supply circuit system.
Refer to .

Q. Is the check result normal?
Go to Step 4.
Diagnose the power supply circuit of the ASC-ECU (Refer to ).

STEP 4. M.U.T.-III other system diagnosis code
Using M.U.T.-III, check that diagnosis code No.U0141 is set by the combination meter system.

Q. Is the diagnosis code set?
Diagnose the combination meter. (Refer to GROUP 54A - Combination Meter, Troubleshooting .) Then go to Step 7.
Go to Step 5.

STEP 5. M.U.T.-III other system diagnosis code
Using M.U.T.-III, check that diagnosis code No.U0121 is set by the ETACS system.

Q. Is the diagnosis code set?
Perform troubleshooting on ETACS-ECU. (Refer to GROUP 54A - ETACS, Troubleshooting .) Then go to Step 7.
Go to Step 6.

STEP 6. Retest the system.

Q. Does the ASC warning display turn ON and OFF normally?
Intermittent malfunction (Refer to GROUP 00 - How to Cope with Intermittent Malfunction .)
Replace the hydraulic unit (ASC-ECU) (Refer to ), and then go to Step 7.

STEP 7. Retest the system.

Q. Does the ASC warning display turn ON and OFF normally?
This diagnosis is complete.
Return to Step 1.