REMOVAL AND INSTALLATION


Pre-removal operationFloor Console Assembly Removal (Refer to GROUP 52A - Floor Console Assembly ).
 Post-installation operation
  • Parking Brake Lever Stroke Check and Adjustment (Refer to ).
  • Floor Console Assembly Installation (Refer to GROUP 52A - Floor Console Assembly ).




Removal steps


1.
 Parking brake switch connector connection
<<A>>
 >>A<<
 2.
 Parking brake rear cable connection


3.
 Parking brake lever assembly


4.
 Parking brake switch


5.
 Adjusting nut

REMOVAL SERVICE POINT

<<A>> PARKING BRAKE REAR CABLE DISCONNECTION
Disconnect the parking brake rear cable according to the procedure below.
1.Release the parking brake, and loosen the adjusting nut.

2.Remove the floor console bracket rear mounting bolts.

3.Slide the floor console bracket rear, and disconnect the parking brake rear cable from the hole shown by the arrows.

INSTALLATION SERVICE POINT

>>A<< PARKING BRAKE REAR CABLE CONNECTION INSTALLATION

Install the parking brake rear cable connection, and then tighten the floor console bracket rear mounting bolts to the specified torque.
Tightening torque: 9.5 ± 3.5 N·m