Code No. P0038: Right Bank Oxygen Sensor (rear) Heater Circuit High Input


OPERATION
- Power is supplied to the heater power terminal (terminal
No. 1) of the right bank oxygen sensor (rear) connector from the engine control relay (terminal
No. 2).
- The heater (terminal No. 3) of the right bank oxygen sensor (rear) connector is
controlled by the power transistor in the engine-ECU (terminal No. 49).
FUNCTION
- The power supply to the right bank oxygen sensor (rear)
heater is controlled by the ON/OFF control of the power transistor in the engine-ECU.
- Heating the right bank oxygen sensor (rear) heater enables the right bank oxygen
sensor (rear) to provide good response even when the exhaust emission temperature is low.
TROUBLE JUDGMENT
Check Conditions
- More than 2 seconds have passed since the engine starting sequence was completed.
- While the right bank oxygen sensor (rear) heater is on.
- Battery positive voltage is 11 -
16.5 V.
- The right bank oxygen sensor (rear) heater current has continued to be higher than
10.5 A for 2 seconds.
PROBABLE CAUSES
- Failed right bank oxygen sensor (rear) heater
- Failed engine-ECU
DIAGNOSIS PROCEDURE |
STEP 1. Perform resistance measurement at B-125 right bank oxygen sensor (rear) connector. |
|
| OK: 11 -
18 Ω
(at 20°C) |
Q.
Is the check result normal?
|
Go to Step 2 . |
|
Replace the right bank oxygen sensor (rear). |
|
STEP 2. M.U.T.-III diagnosis code |
|
Q.
Is diagnosis code set?
|
Replace the engine-ECU. |
|
Intermittent malfunction (Refer to GROUP 00 -
How to Use Troubleshooting/Inspection
Service Points -
How to Cope with Intermittent Malfunctions ). |
|

Replace the right bank oxygen sensor (rear).