REMOVAL AND INSTALLATION <4HN>







Exhaust main muffler and rear floor panel heat protector removal steps


1.
Exhaust main muffler


7.
Exhaust pipe gasket


8.
Exhaust muffler hanger


9.
Rear floor panel heat protector



Centre exhaust pipe and front floor panel rear heat protector removal steps


5.
Clamp


6.
Centre exhaust pipe


7.
Exhaust pipe gasket


10.
Exhaust muffler hanger
<<A>>
>>A<<
18.
Rivet


19.
Front floor panel heat protector



DPF assembly, catalytic converter assembly and front floor panel front heat protector removal steps


2.
Backbone brace


3.
Catalyst temperature sensor


4.
Vacuum hose connection


5.
Clamp


11.
Clamp


12.
DPF assembly


13.
Hanger bracket assembly


14.
Catalytic converter bracket


·
Transfer assembly (Refer to GROUP 22A - Transfer Assembly ).


15.
Oxygen sensor


16.
Clamp


17.
Catalytic converter assembly
<<A>>
>>A<<
20.
Rivet


21.
Front floor front panel heat protector

REMOVAL SERVICE POINT



<<A>> RIVET REMOVAL


caution Be careful not to damage the heat protector with the drill.

Use a drill (6.0 mm) to make a hole in the rivet to break it, and then remove the rivet.

INSTALLATION SERVICE POINT



>>A<< RIVET INSTALLATION



Use a rivet tool shown in the illustration to connect the parts with rivets by the following procedures.
1.Insert the rivet into a corresponding location.
2.Set the rivet tool at a portion A of rivet.
3.While pushing the flange surface of the rivet onto parts to be fixed with the rivet tool, press the handle of the tool.
4.Thin part of portion A of the rivet will be cut off and the parts is fixed in position.