TRANSFER ASSEMBLY REMOVAL AND INSTALLATION


Pre-removal and post-installation operation
  • Engine room under cover front A and side cover removal and installation (Refer to GROUP 51 - Under Cover .)
  • A/T fluid draining and refilling (Refer to .)
  • Transfer oil draining and refilling (Refer to .)
  • Front exhaust pipe removal and installation (Refer to GROUP 15 .)
  • Propeller shaft removal and installation (Refer to GROUP 25 .)
  • Centre member removal and installation (Refer to GROUP 32 .)




Removal steps


·
 Pressure hose assembly, return tube B, Hose bracket (Refer to GROUP 37 .)


1.
 Rear roll stopper


2.
 Transmission case rear roll stopper bracket


·
 Drive shaft RH and output shaft (Refer to GROUP 26 .)
>>A<<
3.
 Transfer assembly


4.
 O-ring

REMOVAL SERVICE POINTS

>>A<< TRANSFER ASSEMBLY REMOVAL
Move the engine and transmission assembly toward the front of the vehicle to make a gap between the engine/transmission assembly and the crossmember. Pull out the transfer assembly through this gap.