REMOVAL AND INSTALLATION



caution
  • *The part indicated by the *1 mark should be temporarily tightened, and then fully tightened with the engine and transmission assembly weight applied on the vehicle body.
  • *The parts indicated by the *2 are the bolts with friction coefficient stabilizer. In removal, ensure there is no damage, clean dust and soiling from bearing and thread surfaces, and tighten them to the specified torque.
Pre-removal and post-installation operation
  • Engine Compartment Under Cover Removal and Installation (Refer to GROUP 51 - Under Cover ).





Front rolling stopper centre member removal steps


1.
Flanged nut


2.
Centre member and body connection


3.
Centre member and crossmember connection


4.
Centre member front rolling stopper assembly


5.
Centre member

>>A<<
6.
Front roll stopper



Rear roll stopper removal steps


7.
Flanged nut


·
Transfer assembly removal (Refer to GROUP 22A - Transmission Assembly ). <M/T> or (Refer to GROUP 23A - Transmission Assembly ). <CVT> or (Refer to GROUP 23C - Transmission Assembly ). <A/T>


·
Catalytic converter assembly removal (Refer to GROUP 15 - Exhaust Pipe, Main Muffler and Catalytic Converter ).<4HN>


8.
Rear rolling stopper

INSTALLATION SERVICE POINTS



>>A<< FRONT ROLL STOPPER INSTALLATION



Install the front roll stopper so that the hole faces toward the vehicle front.