REMOVAL AND INSTALLATION <4HN>



caution The part indicated * mark should be temporarily tightened and then should be fully tightened with the engine weight applied on the vehicle body.
Pre-removal operation
  • Engine Cover Removal (Refer to GROUP 11G - Engine Assembly ).
  • Fender Inner Garnish Removal (Refer to GROUP 42A - Loose Panel ).
  • Wiper Arm and Blade Assembly and Deck Garnish Removal (Refer to GROUP 51 - Windshield Wiper ).

Post-installation operation
  • Engine Cover Installation (Refer to GROUP 11G - Engine Assembly ).
  • Wiper Arm and Blade Assembly and Deck Garnish Installation (Refer to GROUP 51 - Windshield Wiper ).
  • Fender Inner Garnish Installation (Refer to GROUP 42A - Loose Panel ).





Removal steps
<<A>>

1.
Engine mounting bracket

>>A<<
2.
Engine mounting insulator stopper


3.
Engine mounting insulator

REMOVAL SERVICE POINT



<<A>> ENGINE MOUNTING BRACKET REMOVAL




1.Set the engine hanger (Special tool: MB991928 or MB991895).

2.Set the chain of the engine hanger (special tool: MB991928 or MB991895) as shown in the figure.

INSTALLATION SERVICE POINT



>>A<< ENGINE MOUNTING INSULATOR STOPPER INSTALLATION



Install the engine mounting insulator stopper as shown in the figure.