Code No.B16A0 Tail Lamp (RH) Circuit Open <Open circuit in the position lamp (RH) circuit and the tail lamp (RH) circuit>
Code No.B16A7 Tail Lamp (RH) Circuit Short <Short circuit in the position lamp (RH) circuit or the tail lamp (RH) circuit>












DIAGNOSTIC FUNCTION



JUDGMENT CRITERIA



PROBABLE CAUSES



  • Malfunction of position lamp bulb (RH)
  • Malfunction of rear combination lamp unit (RH)
  • Damaged harness wires and connectors
  • Malfunction of the ETACS-ECU

DIAGNOSIS PROCEDURE


STEP 1. Bulb check



Q. Is the check result normal?





STEP 2. Connector check: A-54 headlamp assembly (position: RH) connector


Q. Is the check result normal?





STEP 3. Resistance measurement at the A-54 headlamp assembly (position: RH) connector


(1)Disconnect the connector, and measure at the wiring harness side.
(2)Measure the resistance between the A-54 headlamp assembly (position: RH) connector terminal No. 8 and the body earth.
OK: Continuity exists (2 Ω or less)

Q. Is the check result normal?





STEP 4. Wiring harness check between the A-54 headlamp assembly (position: RH) connector terminal No. 8 and the body earth



  • Check the earth wires for open circuit.

Q. Is the check result normal?





STEP 5. Connector check: C-304 ETACS-ECU connector


Q. Is the check result normal?





STEP 6. Wiring harness check between the A-54 headlamp assembly (position: RH) connector terminal No. 6 and the C-304 ETACS-ECU connector terminal No. 7



  • Check the output lines for open circuit and short circuit.

Q. Is the check result normal?





STEP 7. Connector check: D-10 rear combination lamp (tail: RH) connector


Q. Is the check result normal?





STEP 8. Resistance measurement at the D-10 rear combination lamp (tail: RH) connector


(1)Disconnect the connector, and measure at the wiring harness side.
(2)Measure the resistance between the D-10 rear combination lamp (tail: RH) connector terminal No. 4 and the body earth.
OK: Continuity exists (2 Ω or less)

Q. Is the check result normal?





STEP 9. Wiring harness check between the D-10 rear combination lamp (tail: RH) connector terminal No. 4 and the body earth



  • Check the earth wires for open circuit.

Q. Is the check result normal?





STEP 10. Connector check: C-311 ETACS-ECU connector


Q. Is the check result normal?





STEP 11. Wiring harness check between the D-10 rear combination lamp (tail: RH) connector terminal No. 2 and the C-311 ETACS-ECU connector terminal No. 13



  • Check the output lines for open circuit and short circuit.

Q. Is the check result normal?





STEP 12. Check whether the diagnosis code is reset.


(1)Erase the diagnosis code.
(2)Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
(3)Check if diagnosis code is set.

Q. Is the diagnosis code set?





STEP 13. Substitute a known good rear combination lamp unit (RH), and check the diagnosis code.


(1)Erase the diagnosis code.
(2)Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
(3)Check if diagnosis code is set.

Q. Is the diagnosis code set?