REMOVAL AND INSTALLATION

warning

Never attempt to disassemble or repair the passenger’s air bag cut off switch. If faulty, replace it.

Do not drop or subject the passenger’s air bag cut off switch to impact or vibration. Replace the passenger’s air bag cut off switch, if a dent, cracking, deformation, or rust is present.

Pre-removal Operation

Turn the ignition key to the "LOCK" (OFF) position.

			Removal steps
<<A>>		1.	Negative battery cable connection
		·	Glove box assembly (Refer to GROUP 52A, Instrument Panel Assembly ).
		2.	Passenger’s air bag cut off switch
			Installation steps
	>>A<<	·	Pre-installation inspection
	>>B<<	2.	Passenger’s air bag cut off switch
		·	Glove box assembly (Refer to GROUP 52A, Instrument Panel Assembly ).
		1.	Negative battery cable connection
	>>C<<	·	Post-installation inspection

REMOVAL SERVICE POINT

<<A>> NEGATIVE BATTERY CABLE DISCONNECTION

danger

Wait at least 60 seconds after disconnecting the battery cable before doing any further work. (Refer to

Disconnect the negative battery cable from the battery and tape the terminal to prevent accidental connection and air bag(s) deployment.

INSTALLATION SERVICE POINTS

>>A<< PRE-INSTALLATION INSPECTION

Check the passenger’s air bag cut off switch for dents, breakage and bending and measure the resistance between the terminals, even when installing a new passenger’s air bag cut off switch.

>>B<< PASSENGER’S AIR BAG CUT OFF SWITCH INSTALLATION

warning

If the passenger’s air bag cut off switch is not installed securely and correctly, the passenger’s (front) air bag may not operate normally.

Securely connect the connector.

>>C<< POST-INSTALLATION INSPECTION

1.Reconnect the negative battery cable.

2.Turn the ignition switch to the "ON" position.

3.Does the SRS warning lamp illuminate for about 7 seconds, and go out?
4.If no, refer to troubleshooting (Refer to

5.Does the passenger’s air bag off indicator lamp illuminate for about 7 seconds, and go out?
6.If no, refer to troubleshooting (Refer to