REMOVAL AND INSTALLATION



caution
  • When the throttle body assembly replacement is performed, use the M.U.T.-III to initialize the learning value (Refer to GROUP 00, Precautions Before Service - Initialisation Procedure for Learning Value in MPI Engine ).
  • Do not loosen the fixing screws for the resin cover of throttle body assembly. If the screws are loosened, the sensor incorporated in the resin cover becomes misaligned and the throttle body can not work normally.
Pre-removal Operation
  • Engine Cover Removal (Refer to GROUP 11E, Camshaft )
  • Engine Coolant Draining (Refer to GROUP 14, On-vehicle Service - Engine Coolant Replacement ).
  • Air Cleaner Assembly Removal (Refer to GROUP 15, Air Cleaner ).

Post-installation Operation
  • Air Cleaner Assembly Installation (Refer to GROUP 15, Air Cleaner ).
  • Engine Coolant Supplying (Refer to GROUP 14, On-vehicle Service - Engine Coolant Replacement ).
  • Engine Cover Installation (Refer to GROUP 11E, Camshaft ).





Removal steps

>>B<<
·
Initialisation (Installation only)


1.
Electronic control throttle valve connector


2.
Throttle body water hose connection


3.
Radiator upper hose clamp


4.
Throttle body assembly

>>A<<
5.
Throttle body gasket

INSTALLATION SERVICE POINTS



>>A<< THROTTLE BODY GASKET INSTALLATION


Securely insert the throttle body gasket in the groove of the inlet manifold without causing any torsion or damage to the gasket.

>>B<< INITIALISATION


When the throttle body is installed, removed or replaced, initialize the electronic-controlled throttle valve system according to the procedure below beforehand.
1.Turn the ignition switch from "ON" position to "LOCK" (OFF) position, and then hold "LOCK" (OFF) position for approximately 10 seconds or more.