|
|
Check that the window glass operates smoothly and moves along the rear slide window glass runchannel when the rear slide window glass is fully raised and fully lowered. If there is a problem, adjust by the following procedures:
|
|
|
1.Remove the cab rear end lower trim (Refer to GROUP 52A, Interior trim  ).
|
|
|
2.Remove the waterproof film and rear panel power window regulator assembly (Refer to ).
|
|
3.Stretch the both bends ("A" shown in the figure) of channel guide on the rear panel window regulator assembly.
| note |
The bend of part "A" shown in the figure is used for positioning the rear panel window regulator assembly. However, stretching the part "A" enables the adjustment of rear slide window glass. In addition, keep the part "A" stretched.
|
4.Install the rear panel power window regulator assembly (Refer to ).
5.Activate the anti-trap function successively 3 times; this makes the anti-trap function deactivate.
|
|
6.Raise the rear slide window glass and loosen the channel guide mounting bolts to adjust the window glass slants appropriately.
7.Set the anti-trap function (Refer to ).
|