REMOVAL AND INSTALLATION



Pre-removal and post-installation operation
  • Engine room under cover front A, B, D and side cover removal and installation (Refer to GROUP 51 - Under Cover .)
  • CVT fluid draining and refilling (Refer to .)
  • Transfer oil draining and refilling (Refer to .)
  • Front exhaust pipe removal and installation (Refer to GROUP 15-Front Exhaust Pipe Muffler .)
  • Propeller shaft removal and installation (Refer to GROUP 25-Propeller Shaft .)
  • Centre member removal and installation (Refer to GROUP 32-Crossmember .)





Removal steps


1.
Flanged nut


·
Drive shaft <RH> and output shaft removal and installation (Refer to GROUP 26-Drive Shaft Assembly .)


2.
Dynamic damper


3.
Exhaust manifold bracket
<<A>>

4.
Transfer assembly


5.
O-ring

REMOVAL SERVICE POINTS



<<A>> TRANSFER ASSEMBLY REMOVAL


Move the engine and transmission assembly toward the front of the vehicle to make a gap between the engine/transmission assembly and the crossmember. Pull out the transfer assembly through this gap.