REMOVAL AND INSTALLATION

Pre-removal operation

Power Steering Fluid Draining (Refer to ).
Engine Cover Removal (Refer to GROUP 11E - Engine assembly ).

Post-installation operation

Engine Cover Installation (Refer to GROUP 11E - Engine assembly ).
Power Steering Fluid Refilling and Bleeding (Refer to ).
Drive Belt Tension Adjustment (Refer to GROUP 11A - On-vehicle service - Drive Belt Tension Adjustment <2000>, GROUP 11C - On-vehicle service - Drive Belt Tension Adjustment <3000>, GROUP 11E - On-vehicle service - Drive Belt Tension Adjustment <2400>, GROUP 11G - On-vehicle service - Drive Belt Tension Adjustment <2200>).

		Removal steps
	1.	Alternator and Others Belt (Refer to GROUP 11A - Engine assembly ).
>>A<<	2.	Suction hose connection
	3.	Eye bolt
	4.	Gasket
	5.	Pressure hose connection
	6.	Oil pump assembly

		Removal steps
	1.	Alternator and others belt (Refer to GROUP 11E - Crankshaft Pulley <2400>).
>>B<<	2.	Suction hose connection
	3.	Pressure switch connection
	4.	Eye bolt
	5.	Gasket
	6.	Pressure hose connection
	7.	Harness bracket
	8.	Oil pump assembly
	9.	Oil pump bracket

			Removal steps
		1.	Alternator and others belt (Refer to GROUP 11C - Crankshaft Pulley ).
	>>B<<	2.	Suction hose connection
		3.	Pressure switch connection
		4.	Eye bolt
		5.	Gasket
		6.	Pressure hose connection
<<A>>		7.	Oil pump assembly
		8.	Heat protector
		9.	Oil pump bracket

REMOVAL SERVICE POINT

<<A>>OIL PUMP ASSEMBLY REMOVAL <3000>

When removing the oil pump assembly, remove the stabilizer link and stabilizer bar bracket, shift the stabilizer bar to the left of the vehicle, and then remove the assembly from the front wheel house (right side) (Refer to GROUP 33 - Stabilizer bar

INSTALLATION SERVICE POINTS

>>A<< SUCTION HOSE CONNECTION

Align the suction hose marking within the area shown in the figure and connect the suction hose.

>>B<< SUCTION HOSE CONNECTION

Align the suction hose marking within the area shown in the figure and connect the suction hose.