Inspection Procedure 9: Driver’s Door Lock Switch does not Work. <RH drive vehicles>


caution Before replacing the ECU, ensure that the power supply circuit, the earth circuit and the communication circuit are normal.






PROBABLE CAUSES



  • Malfunction of the exterior transmitter antenna assembly (driver’s side)
  • Malfunction of the lock switch (front: RH)
  • Damaged wiring harness and connectors
  • Malfunction of the KOS-ECU

DIAGNOSTIC PROCEDURE


STEP 1. M.U.T.-III diagnosis code



Q. Is the diagnosis code set?





STEP 2. Connector check: C-104 KOS-ECU connector, E-07 Lock switch (front: RH) connector


Q. Is the check result normal?





STEP 3. Check the wiring harness between the C-104 KOS-ECU connector terminal No. 21 and the E-07 lock switch (front: RH) connector terminal No. 1, and between the E-07 lock switch (front: RH) connector terminal No. 2 and the earth.



  • Check the signal and earth wires for open circuit.
note Before the wiring harness check, check the intermediate connectors C-128 and C-129, and repair if necessary.

Q. Is the check result normal?





STEP 4. Lock switch (front: RH) check



Q. Is the check result normal?





STEP 5. KOS communication test



Q. Is the check result normal?





STEP 6. Check of the troubles



Q. Is the check result normal?