INDIVIDUAL COMPONENT SERVICE


caution
  • If the influence of heat is suspected during painting work, remove the following parts:

    • 93°C or higher: SRS-ECU, air bag module, clock spring, front impact sensor, side impact sensor, rear detect sensor and passenger’s air bag cut off switch
    • 90 °C or higher: Seat belt with pre-tensioner
  • If the SRS components are removed for the purpose of check, sheet metal repair, painting, etc., they should be stored in a clean, dry place until they are reinstalled.
If the SRS components are to be removed or replaced as a result of maintenance, troubleshooting etc., follow the service procedures that follow.

  • Front impact sensors; refer to
  • SRS-ECU; refer to
  • Driver’s air bag modules and clock spring; refer to
  • Passenger’s (front) air bag module; refer to
  • Side-airbag module; refer to
  • Curtain air bag module; refer to
  • Side impact sensors; refer to
  • Rear detect sensor; refer to
  • Seat belt with pre-tensioner; refer to