REMOVAL AND INSTALLATION <Except Euro5b>



Pre-removal Operation
  • Under Skid Plate and Engine Room Under Cover Removal (Refer to GROUP 51 - Under Cover ).
  • Engine Coolant Draining (Refer to GROUP 14 - On-vehicle Service, Engine Coolant Replacement ).
  • Air Cleaner Assembly Removal (Refer to ).
  • Battery and Battery Box Removal (Refer to GROUP 54A - Battery ).
  • Intercooler Inlet Air Hose Removal (Refer to ).
  • Catalytic Converter Removal (Refer to GROUP 17 - Catalytic Converter ).

Post-installation Operation
  • Catalytic Converter Installation (Refer to GROUP 17 - Catalytic Converter ).
  • Intercooler Inlet Air Hose Installation (Refer to ).
  • Battery and Battery Box Installation (Refer to GROUP 54A - Battery ).
  • Air Cleaner Assembly Installation (Refer to ).
  • Under Skid Plate and Engine Room Under Cover Installation (Refer to GROUP 51 - Under Cover ).
  • Engine Coolant Refilling (Refer to GROUP 14 - On-vehicle Service, Engine Coolant Replacement ).





Removal steps


1.
Turbocharger oil feed pipe


2.
Turbocharger oil feed pipe gasket


3.
Turbocharger water return hose connection


4.
Turbocharger water feed pipe


5.
Turbocharger water feed pipe gasket


6.
Turbocharger water feed hose connection


7.
Turbocharger water return pipe


8.
Turbocharger water return pipe gasket


9.
Turbocharger oil return pipe


10.
Turbocharger oil return pipe gasket

>>C<<
11.
Turbocharger oil return pipe gasket


12.
Nut and washer

>>B<<
13.
Turbocharger assembly

>>A<<
14.
Turbocharger gasket


15.
Exhaust manifold cover


16.
Flange nut


17.
Engine hanger


18.
Nut and washer


19.
Exhaust manifold


20.
Exhaust manifold gasket

REMOVAL SERVICE POINT



<<A>> OIL PIPE REMOVAL


caution Take care not to allow foreign objects to get into the oil passage hole of the turbocharger assembly after the oil pipe is removed.

INSTALLATION SERVICE POINTS



>>A<< TURBOCHARGER GASKET INSTALLATION



Position the projection as shown in the illustration.

>>B<< TURBOCHARGER ASSEMBLY INSTALLATION


1.Check the internal surface, the eye bolt and the mating surface of the oil pipe and water pipe for clogging, and clean if necessary.
2.
caution Be careful not to allow foreign material to enter the turbocharger.
If deposits of carbon are accumulated on the turbocharger oil passage, remove them and clean using the compressed air.
3.Add clean engine oil through the oil feed pipe port on the turbocharger.

>>C<< OIL RETURN PIPE GASKET INSTALLATION



Position the projection as shown in the illustration.